Changing the maximum number of LDP ECMP paths

1. In privileged EXEC mode, enter global configuration mode.
   

   device# configure terminal

2. Enable MPLS on the device.
   

   device(config)# router mpls

3. Access LDP configuration mode.
   

   device(config-router-mpls)# ldp

4. Change the maximum number of LDP ECMP paths.
   

   device(config-router-mpls-ldp)# load-sharing 4

   In this example, the maximum number of path is set to 4. The default value is 1. You can enter an integer from 1 to 16.
5. Verify the load sharing configuration.
   

   device# show mpls ldp
   Label Distribution Protocol version 1
   LSR ID: 10.125.125.1, using Loopback 1(deleting it stops LDP)
   Hello interval: Link 5 sec, Targeted 15 sec
   Hold time value sent in Hellos: Link 15 sec, Targeted 45 sec 
   Keepalive interval: 6 sec, Hold time multiple: 6 intervals 
   load-sharing 4
   

   

   Note

   The load sharing configuration is displayed only when the configured value is different from the default value.

The following example shows the previous steps to change the maximum number of ECMP paths.

device# configure terminal
device(config)# router mpls
device(config-router-mpls)# ldp
device(config-router-mpls-ldp)# load-sharing 4