Beam attachment area is at least
0.5 in. (12.7 mm) wide and as long as the largest dimension of the access
point.
Beam mounting surface is less
than 0.650 in. (16.5 mm) thick.
About this task
If you do not want to install the access point on a solid flat surface, you can
attach it to a beam using the beam clip accessory (BRKT-000147A-01). The access
point can be attached to a beam only if the beam is flat, and can support the access
point in all environmental conditions.
Beam clip accessory
Procedure
Attach the beam clip to the main
mounting bracket.
Slide the beam clip accessory
into the rear hinges on either side of the main mounting bracket and slightly
twist it until the clip locks into place.
Beam clip accessory
attached to the main mounting bracket
Place the access point onto the main mounting bracket feet and slide it down to
lock it in place.
Place the beam clip accessory on a beam.
Note
Ensure that you leave enough space between the beam clip accessory screw
and the clamp. This helps to tighten the beam clip accessory screw
easily.
Tighten the beam clip accessory screw to secure the access point in
place.
Beam clip accessory attached to a beam
Connect the Ethernet cable RJ45 into the GE1 port.
