Install the Access Point on a Flat T-bar Using Main Mounting Bracket and KT-135628-01 Adapter

Before you begin

Ensure that the T-bar meets the following conditions before installing the main mounting bracket with the KT-135628-01 adapter on a T-bar:
  • T-bar width can be 15/16 in. (24 mm).
  • T-bar bottom must be flat all the way across.
  • T-bar must be structurally sound.
  • T-bar maximum base thickness must not exceed 0.055 in. (1.400 mm).
  • Ceiling tile may protrude up to 0.35 in. (8.89 mm) below the T-bar.

About this task

If the ceiling tile is not flat and has a protrusion, use the main mounting bracket with the KT-135628-01 adapter. Attach the adapter to the main mounting bracket before attaching the bracket to a T-bar.

Procedure

  1. Attach the T-bar adapter to the main mounting bracket by lining up the small bends on the adapter with the long raised parts on the main bracket.
  2. Pull up the KT-135628-01 adapter locking pin, and twist clockwise.
    After the adapter is put on the main mounting bracket, untwist the locking pin, and ensure that the locking pin goes into the locking pin hole on the main bracket and locks in place.
    Click to expand in new window
    Attach the KT-135628-01 adapter on the main mounting bracket
    Image of the KT-135628-01 adapter being attached to the stainless-steel mounting bracket
    Callout Description
    1 KT-135628-01 adapter
    2 KT-135628-01 T-bar holder
    3 KT-135628-01 adapter locking pin
  3. Slide the KT-135628-01 T-bar holder onto the T-bar and replace the tiles to hold the adapter onto the T-bar.
  4. Attach the RJ45 connector to the GE1 port.
  5. Hold and rock the access point back and forth to ensure that it is securely mounted.
9036535-04 Rev AA