Install the Access Point Using the WALL04 Bracket

About this task

The optional WALL04 (#30516) bracket is used for wall installations, and ships with two Phillips pan head screws and two screw-in anchors. You must purchase the bracket separately.
Note

Note

The locking tab on the WS-MBI-WALL04 bracket must be on the top side during installation.

Procedure

  1. Using the WALL04 bracket as a template, mark and drill two holes on a wall.
    Tip

    Tip

    The best practice is to use the "A" and "B" hole templates on the WALL04 bracket to mark the attachment holes.
    Note

    Note

    When using the "A" or "B" hole template, if the holes are not near the corners of the bracket, you can break off the corner to minimize the amount of bracket that is visible behind the access point.
    Click to expand in new window
    Access point being attached to the WALL04 bracket
    Image of the internal antenna model access point being attached to a square box bracket on a wall. In this image, the bracket corners are kept in-tact.
    Click to expand in new window
    Access point being attached to the WALL04 bracket with the bracket corners broken off
    Image of the internal antenna model access point being attached to a square box bracket on a wall. In this image, the bracket corners are broken off.
  2. Attach the WS-MBI-WALL04 bracket on a wall using two Phillips pan head screws.
    Tip

    Tip

    The best practice is to install the screw-in anchors before attaching the pan head screws during drywall installations.
  3. Connect the GE1 cable to the access point.
  4. Insert the access point into the WALL04 bracket keyhole posts and slide it into place.
  5. Lock the access point at approximately 1/4th in. from the bracket.
9036535-04 Rev AA