Install the Access Point on a Flat T-bar
Using Main Mounting Bracket
Before you begin
Ensure that the T-bar meets the following conditions before installing the main
mounting bracket on a flat T-bar:
T-bar width must be 15/16 in. (24
mm).
T-bar bottom must be flat, all
the way across the ceiling.
T-bar must be structurally
sound.
T-bar maximum base thickness must
not exceed 0.055 in. (1.400 mm).
Ceiling tile over the T-bar must
be flat, all the way across.
About this task
The main mounting bracket is used on a T-bar when the ceiling model is a suspended or
drop ceiling and when there is a T-bar on the ceiling.
Procedure
Remove the ceiling tiles.
Push and rotate the main mounting bracket on the T-bar in such a way that the
center angled locking tabs of the main bracket gets attached to the T-bar.
Install the main mounting bracket on a T-bar
Attach the RJ45 connector to the
GE1 port.
Place the access point on the
bracket feet and slide it down to lock it in place.
Hold the access point and rock
it back and forth to ensure that it is securely mounted.
