If you do not want to use the main mounting bracket that ships with the access point,
you can install the access point directly on a wall using two Phillips pan head
screws.
Tip
The best
practice is to use the main mounting bracket for wall installations.
Procedure
Measure and drill two holes
4.100 in. (104 mm) apart from each other on the wall.
Insert the Phillips pan head screws into the mounting holes on the wall.
Use screw-in anchors, if needed.
Note
Leave 1/8th in.
gap between the screw head and the wall.
Access point direct
wall mount
Connect the Ethernet cable RJ45 into the GE1 port.
Align the access point against
the screw heads and slide it down.
Ensure that the access point is secured in place.
If the access point is loose, unmount it and decrease the distance between the
two screw heads. Then, remount the access point.
