Connecting the LAN/Power to the AP using the RJ45 cable with receptacle

Procedure

  1. Connect the plug end of the RJ45 cable to the LAN1 port in the back of the AP.
  2. Connect the LAN1 cable to the receptacle.
    Note

    Note

    This step must be carried out before mounting the AP onto the bracket.
    Click to expand in new window
    Connecting the LAN cable to the receptacle
  3. Arrange the RJ-45 receptacle cable to stay within the WALL-05 bracket enclosure before mounting the AP.
  4. Mount the AP onto the bracket.
    If you are using the punch-down block, use a punch-down tool with a 110 blade.
    Important

    Important

    Make sure that the wires are punched down professionally. Otherwise the LAN 1 link speed could drop to 100 Mbps, instead of 1000 Mbps.

    There are two standards for patch-panel cable pin-out. Please select the standard used by your facility.

    Click to expand in new window
    Patch-panel Cable Pin-out Colors