Mounting the Bracket to a Junction or Gang Box

About this task

To mount the bracket to a junction or gang box, you can use the mounting bracket or the WALL05 bracket.

Procedure

  1. Place the mounting bracket over the junction box with the captive screw on the left side and the large, flat plate against the wall. The bracket should be attached to a vertical surface.
  2. Align two of the bracket holes with two of the box‘s holes. Use bracket holes that are closest to the center of the bracket. Make sure that the entire box is covered by the bracket.
  3. Using the two pan head machine screws, attach the bracket to the box using the aligned holes. Torque the screws to 9.0 in-lbs.
  4. Connect the LAN/power through the bracket to the AP.
  5. Attach the AP to the mounting bracket.