The following are limitations in ExtremeXOS system architecture that have yet to be resolved.
CR Number | Description |
---|---|
ExtremeSwitching X870 Series Switches | |
xos0065093 | On ExtremeSwitching X870 series switches, when the management port link is actually down, the command show management on the switch, shows the link as active. |
xos0065687 | ExtremeSwitching X870 switches cannot participate in mixed stacks. They can be stacked only with other X870 switches. |
ExtremeSwitching X620 Series Switches | |
xos0065878 | For ExtremeSwitching X620-16p switches, EAPS convergence time is excessive (230 milliseconds) after disabling a copper port with protected VLAN. |
xos0066547 | For stacked ExtremeSwitching X620-16P nodes, PSU information does not appear in output of the show power. |
Summit X460-G2 Series Switches | |
xos0066762 | On Summit X460-G2 switches, VIM-2t ports only support EEE in 10GBASE-T mode (cannot use 1G speed). |
SummitStack | |
xos0067158 |
You cannot synchronize a master switch running a version earlier than ExtremeXOS 22.2 to a target node running ExtremeXOS 22.2 or later. The command fails and the following error message appears: Error: the target slot's partitions are not compatible with the Master's for synchronize. |
Policy | |
xos0065870 | Learning of CEP entries depends on the LLDP/CDP update on active ports and on disabling and enabling CEP. New entries are learned only after receiving new LLDP/CDP information, and not from existing LLDP neighbors and CDP neighbors table. |
xos0065630, xos0065561 | Configuration changes on existing policy mux entries
(changing the policy profile for a convergence endpoint to 0 or a different value,
disabling LLDP or CDP, etc.) do not take effect until re-authorization. As a result,
existing CEP connections remain active and FDB is still learned on policy profile even
though CDP/LLDP neighbor times out and show cdp
neighbor {detail} and show lldp
neighbors is empty. Workaround: You can force reauthorization by clearing a CEP connection:
configure policy convergence-endpoint clear
ports [port_list | all].
|
xos0065870 | Learning of CEP entries depends on the LLDP/CDP update on active ports and on disabling and enabling CEP. New entries are learned only after receiving new LLDP/CDP information, and not from existing LLDP neighbors and CDP neighbors table. |
xos0065657 | If you configure multiple authentication types, failure of a higher priority authentication results in the lower priority authentication being used. |
SNMP | |
xos0066562 |
When upgrading a switch to ExtremeXOS 22.2 from ExtremeXOS 21.1 (or earlier), SNMPv3 default users that were disabled using the command disable snmvp3 default-users become "active" again automatically since the command is deprecated in ExtremeXOS 22.2. Workaround: If needed, users can be individually
disabled (and enabled) using SNMP by manipulating the "usmUserTable" for the
"usmUserStatus" OID. This must be done by a user with a view that allows the
manipulation of the SNMP-USER-BASED-SM-MIB.
|