Use the aplist command to add or remove an AP to or from the service configuration. The aplist command is accessible from the wlan:<WLAN-service-name> context of the CLI when the WLAN service type is standard.
After you run the aplist command, run the apply command to implement the changes.
Note
Network access for the AP3916ic camera function is controlled through policy definition, assigned as a the CAM port. The camera port on the AP3916 is treated as a wired port.For AP3916, the camera always connects to p1.
The AP3912 offers three client ports:
ap-name | Specifies the name of the AP to add or remove from the WLAN service. The no form of the command removes the AP |
radio1 | radio2 | both | Specifies to use radio1, radio2, or both with the WLAN service |
Supported on the AP3912: | |
p1 | p2 | p3 | Specifies which port to configure for the WLAN service. |
Supported on the AP3916: | |
p1 | The camera on the AP3916 always connects to p1. |
The following example adds an AP3912i by AP name to the WLAN service named “test” and then displays the list of Wireless APs with port assignments:
EWC.extremenetworks.com:wlans:test# aplist AP3912i_1637Y-1003100000 p1 p3 EWC.extremenetworks.com:wlans:test# apply EWC.extremenetworks.com:wlans:test# show aplist
EWC.extremenetworks.com:wlans:v1WLAN# aplist 3916ic p1