defaults
The defaults command moves you into the defaults context, which contains commands to configure the Wireless AP‘s default settings. The defaults command is accessible from the ap context of the CLI.
As the Wireless APs discover
and register with the controller, they inherit the properties of the default Wireless AP
setting. Since these defaults must apply to multiple AP platforms, they consist only of
values that are supported on all platforms. To apply options individually to an AP, you
can modify the default Wireless AP settings on that AP either via the Wireless Assistant
GUI or the CLI <serial> context.
The following commands are available in the ap:defaults context:
- ap37xx — See for commands in the ap:defaults:ap37xx context.
- ap38xx — See ap38xx for commands in the
ap:defaults:ap38xx context.
- ap3801 — See ap3801 for commands in the
ap:defaults:ap3801 context.
- ap3805ROW — See ap3805ROW for
commands in the ap:defaults:ap3805ROW context.
- 3912FCC and 3912ROW — See ap3912 for
commands in the ap:defaults:ap3912 context.
- 3916FCC and 3916ROW — See ap3916ROW for
commands in the ap:defaults:ap3916ROW context.
- 3935FCC — See ap3935FCC for
commands in the ap:defaults:ap3935FCC context.
- 3935ROW— See ap3935ROW for
commands in the ap:defaults:ap3935ROW context.
- 3965FCC— See ap3965FCC for
commands in the ap:defaults:ap3965FCC context.
- 3965ROW— See ap3965ROW for
commands in the ap:defaults:ap3965ROW context.
- assign — See assign for commands in the ap:defaults: context.
- learnac
- aclist
- move