Configure LAG Ports

Use this procedure to configure Link Aggregation Group (LAG) interfaces on Universal Compute Platform.

Note

Note

Make sure to configure LAG on the switch that connects to the LAG ports. Otherwise, the LAG connection fails.
  1. Go to Administration > System > Network Setup.
  2. If you want to aggregate any data ports, under L2 Ports, assign data ports to each LAG interface that you want to configure:
    1. For LAG1, select each data port from the Member Ports of LAG column that you want to add to this LAG.
    2. For LAG2, select each data port from the Member Ports of LAG column that you want to add to this LAG.
    3. Select Save and then select OK.
      The LAG interface inherits the VLAN assignments automatically from newly added port members.
  3. If you want to aggregate the ICC ports, under ICC Interfaces, select LAG.
  4. Complete the LAG interface configuration for each new LAG interface:
    1. Under Interfaces, select the new LAG interface.
    2. Configure the interface settings. For more information, see Create New Interface Settings.
    3. Select Save.
9039470-00 Rev.AA