Network Login must be disabled on a port before you can delete a
VLAN that contains that port. You can set a reauthentication
maximum counter value to indicate the number of reauthentication trials after which the
supplicant is denied access or given limited access.
-
To enable 802.1X network login on the switch, use the
following command:
enable
netlogin dot1x Any combination of types of authentication can be enabled on the
same switch. At least one of the authentication types must be specified on the CLI.
-
To disable 802.1X network login on the switch, use the
following command:
disable
netlogin dot1x
-
To enable 802.1X network login on one or more ports, use
the following command:
enable
netlogin ports portlist dot1x
-
To disable 802.1X network login on one or more ports, use
the following command:
disable
netlogin ports portlist dot1x
-
To configure the reauthentication counter values, use the
following command:
configure
netlogin dot1x timers
