Extreme 9920 Software Configuration Guide, 21.1.0.0 Version 21.1.0.0.
>
Platform and Infrastructure Services
>
Management Services
>
Running Configuration
> Reset Configuration
Published June 2021
Search this document
Print this page
Email this page
View PDF
Previous
Next
Preface
Text Conventions
Documentation and Training
Getting Help
Providing Feedback
What's New in this Document
Introduction to the NPB Application
NPB Application Overview
Supported Device Information
Network Traffic Monitoring Preparation
Access Control List Overview
Create an IP Access Control List
Configure an IPv6 Access Control List
Create a MAC Access Control List
Encapsulation Overview
Configure Encapsulation
Listener Policy Overview
Create a Listener Policy
Egress Overview
Egress Policies
Create an Egress
Egress-Group Overview
Create an Egress Group
Route-Map Overview
Create a Route Map
Interface Overview
Create an Interface
Ingress-Group Overview
Create an Ingress Group
Network Traffic Monitoring
Encapsulation
Configure Encapsulation
Listener Policies
Configure a Listener Policy
Egress
Configure an Egress Policy
Route-Map
Map ACLs with Route-Map
Create Egress Group
Ingress
Ingress
Configure an Ingress Policy
View Ingress-Group Details
Replication
Configure Replication
Header Modification
Header-Modification Overview
Header-Modification Flow
Tag-Stripping Overview
802.1BR Tag-Stripping
Configure 802.1BR Tag-Stripping
VLAN Header Tag Stripping
Configure VLAN Tag Stripping
VN-Tag Stripping
Configure VN-Tag Stripping
Tag Addition
Configure Tag Addition
Packet Truncation and Termination
Packet Truncation Flow
Configure Packet Truncation
Tunnel Termination Flow
Forward Incoming Traffic
Drop Incoming Traffic
Filter GTP/SCTP/VXLAN Message Header
Filter GTP Tunneled HTTP Messages
Onboard Packet Capture
PCAP File Management
PCAP File Encoding
PCAP File Decoding
Configure Packet Capture
Configure Ingress and Egress ACL Capture
View Captured Packets
Tunnel Termination
Non-Transport Tunnel Termination
Transport Tunnel Termination
Terminate Non-Transport Tunnels
Terminate Transport Tunnels
View Transport Tunnel Statistics
Terminate and Scope Shift Matrix
L2 Protocol Services
L2 Protocol Services
OpenSource L2 Protocol Stack
Link Aggregation Overview
Static LAG
Traffic Aggregation
Configure Static LAG
Load Balancing
Enable Load Balancing
SNMP Monitoring
Supported SNMP Traps
Configure the SNMP Community String
Configure an SNMP-Trap Receiver IP Address
Monitor Events with SNMP
Platform and Infrastructure Services
Interface Manager Service
Maximum Transmission Unit
LAG Manager
Management Services
Command Line Interface
DB Services
Running Configuration
Apply Configuration
Reset Configuration
Managing Flash Files
Chassis Manager
Stratum
Line Card
Port Management
Configure Breakout Mode
Port Creation
Network Time Protocol
Network Time Protocol Server
Configure NTP
gRPC API Gateway
Logging
Event Logging
Forward Agent Logs
Reset Configuration
Before you begin
Before upgrading or downgrading the firmware, backup the running configuration.
Procedure
Save default configuration to running configuration to reset device configuration.
device# copy default-config running-config
