The following issues were resolved in ExtremeXOS 22.7.1-Patch1-15. ExtremeXOS 22.7.1-Patch1-15 includes all fixes up to and including ExtremeXOS 11.6.5.3, and earlier, ExtremeXOS 12.0.5, ExtremeXOS 12.1.7, ExtremeXOS 12.2.2-patch1-12, ExtremeXOS 12.3.6, ExtremeXOS 12.4.5, ExtremeXOS 12.5.5, ExtremeXOS 12.6.3, ExtremeXOS 12.6.5, ExtremeXOS 12.7.1, ExtremeXOS 15.1.5, ExtremeXOS 15.2.4, ExtremeXOS 15.3.3, ExtremeXOS 15.4.1, ExtremeXOS 15.5.1, ExtremeXOS 15.5.2, ExtremeXOS 15.6.1, ExtremeXOS 15.6.2, ExtremeXOS 15.7.1, ExtremeXOS 16.1, ExtremeXOS 16.1.2, ExtremeXOS 16.1.3, ExtremeXOS 21.1, ExtremeXOS 22.1, ExtremeXOS 22.2, ExtremeXOS 22.3, ExtremeXOS 22.4, ExtremeXOS 22.5, ExtremeXOS 22.6, and ExtremeXOS 22.7. For information about those fixes, see the release notes for the specific release.
CR Number | Description |
---|---|
General | |
xos0075914 | DHCP: DNS domain names from a server are not updated to the DNS proxy. |
xos0076092 | ExtremeXOS VM: DNS server information obtained from DHCP is not installed properly. |
xos0076153 | Fabric Attach (FA) uplink port is removed from FA Mgmt VLAN after ZTP+ configuration is pushed. |
xos0076376 | ELRP packets are transmitted with checksum errors. |
xos0076430 | Process hal ends unexpectedly with signal 11 after unconfiguring a standby slot when policy is enabled. |
xos0076447 | TLS transactions sometime encounter issues when clients send packets after a delay. |
xos0076593 | OSPF AS external routes are removed when one of the two paths go down out of which one is inter area path and another is intra area path. |
xos0076686 | For ExtremeXOS 16.2 and later, SSH has a 3–5 seconds delay for prompt password window to appear. |
xos0076705 | Cable diagnostics are not working on Summit X460G2-16mp switches. |
xos0076764 | After failover, OSPFv3 routes are not removed from new master node. |
xos0076186 | ONEPolicy rules are not taking effect if CoS is configured in the profile. |
xos0076956 | IPFIX does not work on a stack when a master node does not support IPFIX. |
xos0076816 | The NTP association takes a while to be updated when the interface goes down or comes back up. |
xos0077005 | In an STP with MLAG configuration, ISC port cost should appear as "0" under the command show stp domain_name ports output. |
Extended Edge Switching | |
xos0076250 | One-armed Extended Edge Switching MLAG cannot be formed using MLAG ID 1 and 2. |
xos0076298 | With cross-connected MLAG configuration, a few CSP sessions are not opened after multiple failovers of controlling bridge (CB). |
xos0075645 | Extended Edge Switching ring goes to severed state after rebooting controlling bridge (CB) with rebalancing on. |
xos0076323 | Extended Edge Switching ring stays in "Formation disabled" state after rebooting a tier 1 slot, or disabling, and then enabling, native cascade ports. |
xos0076318 | Extended Edge Switching ring remains in severed state after rebooting all slots with traffic. |
xos0076295 | The output of the command show vpex port is not showing MLAG ID information when more than a single one-arm MLAG ring is configured. |
xos0076299 | Extended Edge Switching ring: Multicast traffic loss occurs when adding a new member port to a native cascade LAG. |
xos0076387 | Extended Edge Switching ring: OSPF goes down when adding a new member port to a native cascade LAG. |
xos0076149 | Error log "pibAddPortToDot1BrVlanBitMap" occurs when Extended Edge Switching MLAG ring is coming up after a reboot. |
xos0076154 | On ring common (RC) link, LAG member ports are not added as aggregator. |
xos0076161 | One-armed MLAG: Extended Edge Switching remains in the "Formation Disabled" state after disabling, and then enabling, of the native cascade port. |
xos0076227 | In Extended Edge Switching ring topology after rebooting a bridge port extender (BPE) in the severed state, Multicast traffic is dropped. |
xos0076242 | After a ring common link flap, the Extended Edge Switching ring sometimes does not recover and stays in the "Severed" state. |
xos0076245 | Extended Edge Switching ring: IPMC "Unable to Del L2" error logs occur when deleting ports from VPLAG. |
xos0076343 | Traffic loss occurs after enabling LAGs on extended VLAN ports. |
xos0076348 | In an MLAG and Extended Edge Switching ring topology, when trying to form a ring from a cascade chain, traffic is dropped. |
xos0076371 | After a controlling bridge (CB) failover, LACP sessions go down resulting in traffic loss. |
xos0076557 | Ring common link LAG member does not converged properly in cross-connect MLAG ring. |
xos0076607 | One-armed MLAG: Flood traffic is blackholed after an intermediate slot is removed. |
xos0076460 | Rebalancing is not happening after a slot is removed from a cross-connect MLAG Extended Edge Switching ring. |
xos0076628 | After a controlling bridge (CB) reboot, Multicast traffic loss occurs for slots connected by a one-armed ring. |
xos0073946 | On Extended Edge Switching controlling bridge (CB) switches, the show inline-power stats command takes longer than usual to display the output, and sometimes it returns "Timeout occurred while retrieving information from hardware." messages. |
xos0076462 | Cross-connect MLAG: LAG members are not added after adding a new slot with rebalancing turned on. |
xos0076398 | The time taken for the an eight-node Extended Edge Switching ring(with two PoE slots) to go to the complete state is excessive (approximately 6 mins). |
xos0076689 | One-armed MLAG: Disabling, and then enabling, ports on a controlling (CB) breaks the MLAG-Extended Edge Switching ring and it remains in a severed state. |
xos0076541 | Flood traffic is dropped at bridge port extender (BPE) if A VLAN is added to the extended port after breaking the ring. |
xos0076765 | The hal process ends unexpectedly when a one-armed MLAG ring is formed with an MLAG ID greater than 64,000. |
xos0075272 | "UV/OV" fault is not cleared after the PoE limit is exceeded, and then returned back within the acceptable range. |
xos0076965 | After an ISC flap in one-armed ring topology, FDB is not learned on a slot. |