Displays the contents of an L2PT profile.
| profile | Displays profile that defines L2PT configuration for L2 protocols. |
| profile_name | Displays only the specified profile. |
Disabled.
Use this command to display the contents of an L2PT profile.
The following is an example of the command's output:
# show l2pt profile
DSCP
Profile Name Protocol Filter Name Action CoS DSCP Replace
-------------------------------- -------------------------------- ------ --- ---- ------
my_l2pt_access_prof my_list tunnel 1 63 Yes
my_other_list tunnel 7 0 No
my_l2pt_network_prof mylist encap 20 No
my_other_list encap 8 No
my_none¬_list none 25 No
# show l2pt profile my_l2pt_access_prof
DSCP
Profile Name Protocol Filter Name Action CoS DSCP Replace
-------------------------------- -------------------------------- ------ --- ---- ------
my_l2pt_access_prof my_list tunnel 1 23 Yes
my_other_list tunnel 7 0 No
This command was first available in ExtremeXOS 15.5.
Support for DSCP was added in ExtremeXOS 31.3.
This command is available on all ExtremeSwitching Universal switches.