Connect a Power Supply

Before you begin

Obtain a Powertron 12V DC power supply. The power supply is ordered separately. See the table below.
Caution

Caution

Only use Extreme approved power supplies for your access point. Unapproved third-party components can damage your AP.
Table 1. Power Accessory
Part number Description
37215

PWR 12V DC, 2A (24W), 2.5 mm X 5.5 mm connector

About this task

You can power the AP through the ETH0 RJ45 Ethernet port. But if you prefer an external power supply, then you can use the 12V DC power supply. There is no wall mount bracket for the power supply.

See the Power Profile for power consumption specifications.

Note

Note

Power over Ethernet (PoE) is disabled when you use an external power supply.
Click to expand in new window
AP3000 Power connector
The AP3000X access point power port is located to the left of the ETH1 port.

Procedure

Plug the power supply into the 12-volt power connector.
The LED lights up.
9037812-00 Rev AD