AP302W Features

The access point has the following features:

Radio technology:
- 802.11ax radio, 2×2∶2 2.4 GHz
- 802.11ax radio, 2×2∶2 5 GHz
- Integrated Bluetooth Low Energy (BLE) and Zigbee
Radio modes:
- 5 GHz/2.4 GHz – fixed
- 5 GHz/5 GHz – dual 5 GHz
- 5 GHz with 2.4 GHz/5 GHz – sensor
Console port: custom micro-USB cable
Six, 10/100/1000 Mbps ports:
Rear ports:
- One Ethernet (ETH) port with Power over Ethernet (PoE) in
- One pass through port
Bottom ports or user access ports:
- Two ETH ports
- One ETH port with power-sourcing-equipment (PSE)
- One pass through port
One LED. The LED will be on during reset
One software reset button
One Kensington lock
One USB 2.0 type A connector, supports up to 2.5W
Power: PoE 802.3at and 802.3af (see power table for details)
Antennas:
- Three internal omni-directional 2.4G/5G dual-band antennas
- One internal omni-directional 5G antenna
Temperature
- Operating temperature: 0 °C to +40 °C (+32 °F to +104 °F)
- Non-operating temperature: −40 °C to +70 °C (−40 °F to +158 °F)
Enclosure: plastic

Image of the AP302W access point front side highlighting the light sensor.

Table 1. AP302W front face component
Callout	Description
1	Light sensor

Image of the AP302W access point highlighting the rear features. The feature callouts are described in the Table: Rear feature components.

Table 2. AP302W rear feature components
Callout	Description
1	ETH0/PoE in port
2	Pass through port
3	Console port
4	Reset button

Note

The rear ports are used for access point to system connections.

Bottom ports on the AP302W access point. The port descriptions are highlighted in Table: AP302W bottom port description.

Table 3. AP302W bottom plug-in ports description
Callout	Description
1	12 VDC power supply
2	Pass through port
3	ETH1 or PoE out port
4	ETH2 port
5	ETH3 port
6	Status LED

Note

The bottom ports or user access ports can be used as plug-in ports or through wireless connection. You will be able to access only the bottom ports after the access point is installed.