The AP3915e access point can be mounted onto a beam using a beam clip accessory (BRKT-000147A-01) to
the main mounting bracket.Pre-installation checklist:
- The beam must be able to support the AP in all environmental conditions.
- The beam should be flat.
Before attaching the AP onto a beam, verify that:
- Beam attachment area is at least 0.5” (12.7mm) wide and as long as the AP‘s largest
dimension.
- Beam mounting surface is less than 0.650” (16.5mm) thick.
To attach an AP to a beam, attach a beam clip (Accessory
BRKT-000147A-01) to the main mounting bracket:
-
Attach the adapter to the mounting
bracket by using a twisting motion.
Attaching the beam clip to the main mounting bracket
-
Attach the mounting bracket to the
AP.
-
Place the adapter on a beam in such a
way that there is enough space between the screw and clamp to be tightened.
-
Use the screw and clamp on the top of the adapter to secure the AP in place on the
beam.
Attaching the beam clamp on a beam
-
Insert the Ethernet plug into the AP.
