The optional WS-MBI-DCMTR01 (#30518) bracket
can also be used for T-bar installations without the mounting bracket.
Pre-Installation
checklist:
T-bar width must be 9/16” (15mm), 15/16” (24mm), 1.5” (38mm).
T-bar minimum base thickness: N/A; must be structurally sound.
T-bar maximum base thickness is 0.118” (3mm).
T-bar can have a maximum protrusion of 0.625” (15.8mm).
Maximum protrusion of the ceiling tile can be 0.625” (15.8mm).
Remove the ceiling panels around the
drop ceiling T-bar rail.
Open the movable sliding part of the
T-bar to give the stationary and slider T-bar more space.
Hook the stationary end of the T-bar
bracket onto the T-bar.
Tilt the T-bar up slightly in such a way that you are holding the stationary and
movable sides of the bracket. 4 Squeeze the bracket parts together until you hear the
T-bar locking tab click into place.
Slide the T-bar ceiling mount bracket base into the back of the access point. The
locking tab fits into a groove in the outside of the AP.
Mounting the AP3915e unit onto a WS-MBI-DCMTR01
Bracket
Hold the AP and rock it back and forth to ensure that it is securely mounted.
Attach the Ethernet cable‘s RJ45 connector to the LAN1/GE1 port and place the ceiling
tile back in place.