Mounting the AP to a wall using the Main Mounting bracket

The main mounting bracket (#37201) ships with the AP and can be used to mount the AP onto a wall. This is the recommended method of installation for a wall mounting procedure.
  1. Remove the mounting bracket attached to the back of the AP.
  2. Use the mounting bracket as a template and mark the hole centers on the wall.
    Note

    Note

    The four feet of the bracket must be horizontal and pointing to the right. The flat part of the large surface must be touching the wall.
  3. Drill two holes 83mm (3.270”) apart from each other on the wall where you want to mount the AP.
  4. Insert the screws through the bracket and into the holes. Use the screw-in anchors if needed.
  5. Insert the Ethernet cable‘s RJ45 connector into the LAN1/GE1 port.
  6. Slide the AP onto the bracket‘s four feet. Ensure that the AP is secured in place and tightened.
9035130-03