Adjusting the Camera
After the AP is mounted, adjust the camera as needed:
-
To adjust the rotational camera movement, pull and
hold the rotating locking pin outwards while rotating the camera. Release the
locking pin when the camera is positioned.
-
To adjust the tilt movement, remove the thumbscrew
caps and loosening the thumbscrews. Then, without touching the camera face, move
the camera to the desired tilt angle. Tighten the thumbscrews and put the caps
back on. Torque the screws to 7.0 in-lbs.
-
Remove the plastic protective cover from the face
of the camera.