About this task
The
access point can be mounted onto a beam using a beam clip accessory (BRKT-000147A-01) to
the main mounting bracket.
Before you begin
- The beam must be able to support the AP in
all environmental conditions
- The beam should be flat
Before attaching the AP onto a beam, verify that:
- Beam attachment area is at least 0.5 in.
(12.7 mm) wide and as long as the AP‘s largest dimension
- Beam mounting surface is less than 0.650 in.
(16.5 mm) thick
To attach an AP to a beam, attach a beam clip (accessory BRKT-000147A-01) to the main mounting
bracket:
Procedure
-
Attach the adapter to the
mounting bracket by using a twisting motion.
-
Attach the mounting bracket to the AP.
-
Place the adapter on a beam in such a way that there is enough space between
the screw and clamp to be tightened.
-
Use the screw and clamp on the top of the adapter to secure the AP in place on
the beam.
-
Insert the Ethernet plug into the AP.
