Mount the Access Point to a Wall Using an
Optional Wall and Box Bracket
Learn how to install the access point to a wall using the WALL-04 bracket part.
About this task
Mounting the AP to a flat ceiling requires the WS-MBI-WALL04 (#30516) bracket, two
Philips Pan-head screws, and two screw-in anchors. They must be purchased
separately.
Procedure
Install the WS-MBI-WALL04
bracket on a wall/ceiling with the two screws and screw-in anchors.
Note
The locking tab on the WS-MBI-WALL04 bracket must be on the top side
during installation.
Mounting the AP using
the WS-MBI-WALL04 Bracket
Use the WS-MBI-WALL04 as a template and mark the holes to be used to
mount the AP. It is recommended to use the holes marked "A" or "B".
Drill the holes and attach the bracket using the screws and screw-in
anchors.
Note
When using the "A" or "B" holes, if the holes are not near the corners of
the bracket, you can break off the corner to decrease the bracket's
visibility once the AP is installed.
Mounting the AP using
the WS-MBI-WALL04 Bracket (when bracket corners are broken off)
Connect the LAN or Ethernet cable to the
AP.
Insert the AP onto the keyhole posts and
slide the AP.
