Uninstall XCO on TPVM in a Single-Node and Multi-Node Deployment

When XCO is uninstalled, XCO services are stopped, and the database and directories are removed.

1. (On a single-node deployment) From the SLX device console, run the following command to uninstall XCO:
   

   device# no efa deploy
   

   1. When prompted to continue, enter y.
      As the uninstallation proceeds, messages display showing the uninstallation progress.
2. (On a multi-node deployment) Stop and then start the TPVM to ensure there are no DNS resolution issues.
   

   device# tpvm stop
   device# tpvm start

   

   Note

   1. For a fresh deployment of XCO 3.2.x, 3.3.x or 3.4.x, uninstall any multi-node deployments of XCO 3.1 or earlier.
   2. After the uninstallation, run the sudo rm -rf /etc/keepalived/keepalived.conf command on both XCO nodes.

      Running the sudo rm -rf /etc/keepalived/keepalived.conf command cleans up the keepalived file with the old configuration and does not conflict with same file from new installations.

3. (On a multi-node deployment) On the node where XCO is installed, run the following command to uninstall XCO:
   

   device# no efa deploy
   

   1. When prompted, select Remove the current XCO Stack.
      As the uninstallation proceeds, messages display showing the uninstallation progress.