Configuring the Service Port Using the Web Interface

To configure the service port, or network management port, on a 200 Series switch using the web interface, follow these steps:
  1. Log on to the switch using your web browser.
  2. Open the Service Port IPv4 Configuration page: System > Connectivity > Service Port IPv4.
  3. Define values for the service port:
    1. In the Service Port Configuration Protocol field, click None.
    2. In the following fields, supply the appropriate values for the interface:
      • IP Address
      • Subnet Mask
      • Default Gateway
    3. In the rest of the fields, accept the default values.
      Click to expand in new window
      Fields for Configuring the Service Port
  4. Click Submit.
The service port is ready for use.