The AP5060D and AP5060U have the following Ethernet ports:
ETH0, ETH1: (2) wired Ethernet ports (RJ45).
ETH0: 100/1000/2500/5000/10000 Mbps auto-sensing link speed Ethernet port, PoE PD.
ETH1: 100/1000/2500/5000/10000 Mbps auto-sensing link speed Ethernet port, PoE, PD in or 15.4W PSE out mode (requires 802.3bt on ETH0).
802.3az Energy-Efficient Ethernet (EEE).
A console port for troubleshooting.
| Number | Label | Description |
|---|---|---|
| 1 | Ground | A ground terminal for lightning protection. |
| 2 | Vent | |
| 3 | ETH1 | Ethernet port. |
| 4 | ETH0 | Ethernet port. |
| 5 | Console | Micro USB console port for a serial connection between your management system and the access point. Use the port when you troubleshoot the AP. Tip: The best practice is to use the Extreme Networks micro USB cable (ACC-WIFI-MICRO-USB). When you connect to the device, the management station must have a VT100 emulation program, such as the terminal emulator TeraTerm Pro or Hilgraeve HyperTerminal. Set your baud rate to 115200.
Note: The console port can only be used with the Extreme Networks console cable. You could damage the AP if you use another cable.
|