Wall Installations

The access point can be attached to a wall or flat surface with:

• KT-147407-02 (+/-15 degree tilt)

• KT-150173-01 (12 inch extension)

• KT-147407-02 plus KT-150173-01 (12 inch extension plus +/-15 degree tilt)
• MBO-ART03 (7.5", 9" or 10.5" extension plus 2 axis +/-80 degree tilt)

Note

The M6 hex-head screws and screw-in anchors must be provided by the installer.

The following hardware is required when installing the access point on a flat surface using the KT-147407-02 bracket:

• One access point
• Flat part of the KT-147407-02 bracket with two holes on the metal surface.
• 1-axis tilt bracket.
• KT-150173-01 extension arm and associated M12 hardware. (optional)
• Six M6 screws for KT-147407-02 bracket, and bracket to AP, assembly.
• Four M6 hex-head screws
• Screw-in anchors if the access point is being mounted on a wood wall or a concrete surface.

Note

The M6 hex-head screws and screw-in anchors must be provided by the installer.

If you install the access point to the wall using the ART03 bracket, use the following hardware:

• One access point
• MBO-ART03 articulating mounting bracket
• Four M6 hex-head screws
  • Two M6 hex-head screws to attach the bracket to the access point
  • Two M6 hex-head screws to attach the bracket to the wall or a flat surface.

Note

The cable glands should face down when you install the access point on a wall.