show eapol sessions
Display Extensible Authentication Protocol (EAPoL) and non-Extensible Authentication
Protocol (NEAP) authentication sessions on the switch.
Syntax
-
show eapol sessions
eap verbose
-
show eapol sessions
eap vlan <1-4059>
-
show eapol sessions
eap {slot/port[/sub-port][-slot/port[/sub-port]][,...]}
-
show eapol sessions
neap verbose
-
show eapol sessions
neap vlan <1-4059>
-
show eapol sessions
neap {slot/port[/sub-port][-slot/port[/sub-port]][,...]}
Command Parameters
- {slot/port[/sub-port][-slot/port[/sub-port]][,...]}
- Identifies the slot and port
in one of the following formats: a single slot and port (slot/port), a range
of slots and ports (slot/port-slot/port), or a series of slots and ports
(slot/port,slot/port,slot/port). If your platform supports channelization
and the port is channelized, you must also specify the sub-port in the
format slot/port/sub-port.
- vlan <1-4059>
- Specifies the VLAN ID in the
range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the
system reserves VLAN IDs 4060 to 4094 for internal use. If you enable VRF
scaling and SPBM mode, the system also reserves VLAN IDs 3500 to 3998. VLAN
ID 1 is the default VLAN and you cannot create or delete VLAN ID 1.
- verbose
- Displays non-EAPoL client MAC
information.
Usage Guidelines
This command does not apply to all hardware platforms. For more information about
feature support, see VOSS Feature Support Matrix.