Replacing Bridge Port Extenders

You can replace bridge port extenders (BPEs) in existing Extended Edge Switching topologies.

This procedure explains how to replace a BPE with another BPE of the same model. If you want to replace an existing BPE with a different model, you need to remove the existing BPE (see Removing Bridge Port Extenders from Rings), and then add the new BPE (see Inserting Additional Bridge Port Extenders on Cascades).

Note

For cascade topologies, control plane/traffic is disrupted on the cascade below the BPE being replaced until the new BPE is connected and accepted into the cascade; for ring topologies, control plane/traffic is disrupted only briefly while the cascades re-form. For more information about how rings behave, see Extended Edge Switching Rings.

To replace a BPE:

Detach the cables and remove the existing BPE. In ring topologies, connectivity is maintained to the other BPEs.
Attach the cables to the new BPE.

Published March 2020prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback