Enabling and Disabling 802.1X Network Login

Network Login must be disabled on a port before you can delete a VLAN (Virtual LAN) that contains that port. You can set a reauthentication maximum counter value to indicate the number of reauthentication trials after which the supplicant is denied access or given limited access.

To enable 802.1X network login on the switch, use the following command:
enable netlogin dot1x Any combination of types of authentication can be enabled on the same switch. At least one of the authentication types must be specified on the CLI.
To disable 802.1X network login on the switch, use the following command:
disable netlogin dot1x
To enable 802.1X network login on one or more ports, use the following command:
enable netlogin ports portlist dot1x
To disable 802.1X network login on one or more ports, use the following command:
disable netlogin ports portlist dot1x
To configure the reauthentication counter values, use the following command:
configure netlogin dot1x timers

Published March 2020prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback