Attaching a PW profile to a bridge domain

A pseudowire (PW) profile is applied by attaching it to a bridge domain.

Before it is attached to a bridge domain, the PW profile must be configured.

Perform the following task to attach a PW profile to a bridge domain.

From privileged EXEC mode, enter the global configuration mode.
```
device# configure terminal
```
Enter bridge domain configuration mode.
```
device(config)# bridge-domain 501
```

Configure a PW profile for the bridge domain.

device(config-bridge-domain-501)# pw-profile pw_example

Return to privileged EXEC mode.
```
device(config-bridge-domain-501)# end
```

Verify the configuration.

device# show bridge-domain 501

Bridge-domain 501
-------------------------------
Bridge-domain Type: MP , VC-ID: 501
Number of configured end-points:  2 , Number of Active end-points: 2
VE if-indx: 0, Local switching: TRUE, bpdu-drop-enable: TRUE
PW-profile: pw_example, mac-limit: 0
VLAN: 501, Tagged ports: 1(1 up), Un-tagged ports: 0 (0 up)
Tagged Ports: eth1/6.501 
Un-tagged Ports: 
Total VPLS peers: 1 (1 Operational):

VC id: 501, Peer address: 10.9.9.9, State: Operational, uptime: 4 sec           
      Load-balance: True , Cos Enabled: False, 
      Tunnel cnt: 4
      rsvp  p101(cos_enable:False cos_value:0) 
      rsvp  p102(cos_enable:False cos_value:0) 
      rsvp  p103(cos_enable:False cos_value:0) 
      rsvp  p104(cos_enable:False cos_value:0) 
      Assigned LSPs count:4 Assigned LSPs:p101 p102 p103 p104 
      Local VC lbl: 989041, Remote VC lbl: 983040, 
      Local VC MTU: 1500, Remote VC MTU: 1500, 
      Local VC-Type: 5, Remote VC-Type: 5

Example

The following example shows how to attach a PW profile named pw_example to bridge domain 501.

device# configure terminal
device(config)# bridge-domain 501
device(config-bridge-domain-501)# pw-profile pw_example