All installed fan modules must blow air in the same direction and must match the airflow
direction of the installed power supplies.
Note
The operating-system software cannot
display the airflow direction.
Remove the PSUs and fan modules by
removing the two captive retaining screws and sliding all components out of the
switch.
Note
The operating-system software cannot display the airflow direction.
Remove PSUs and fan
modules
Use a Phillips #1 screwdriver to
loosen the chassis screw.
Chassis switch screw
front-to-back airflow
Use a flathead screwdriver to change
the chassis switch. The following figure is an example of changing front-to-back
airflow to back-to-front airflow.
Front-to-back airflow
chassis position
Back-to-front airflow
chassis position
Use a Phillips #1 screwdriver to
tighten the chassis screw.
Chassis screw
back-to-front position
Carefully slide the PSUs and fan
modules back into the switch.
Remove PSUs and fan
modules
Tighten the two captive retaining screws to secure the components.