Configuring Update Destination MAC in sFlow Streams for Routed Packets

Enable sFlow globally before configuring this setting. For more information, see Configuring sFlow globally.

Enter the configure terminal command to change to global configuration mode.
```
device# configure terminal
```
Enable Update Destination MAC in sFlow Streams.
```
device (config)# sflow update-destination-mac
```
Confirm the sFlow configuration status by using the show sflow or show sflow all commands. You can also use the show running-config command.
```
device# show sflow
```
Clear any existing sFlow statistics to ensure accurate readings.
```
device# clear sflow statistics
```
Note
No specific configuration is required for MPLS other than enabling sflow on physical interfaces.