Basic switch management with NETCONF overview
Refer to the
Extreme SLX-OS Administrator‘s
Guide for the following related information:
- Conceptual and overview information
- Using DHCP Automatic Deployment (DAD)
- Procedures for configuring the Ethernet
management interface
- Basic switch configuration using the
Extreme SLX-OS command line interface (CLI)
Using the NETCONF interface, you can perform the following basic switch configuration operations described in this chapter:
- Use the <edit-config> RPC to set host
attributes, configure a switch banner, enable or disable first failure data
capture (FFDC), and configure logging.
- Use custom actions to enable or disable a chassis,
reboot a switch, obtain slot and module status, and upload supportSave data.
- Use the <show-raslog> custom RPC to return RASlog messages.
Switch management parameters described in this
chapter are defined mostly in the brocade-ras, brocade-linecard-management, and
brocade-chassis YANG modules. For structural maps of these YANG modules, refer to the Extreme SLX-OS YANG Reference
Manual. For definitions and explanations of parameters, refer to the
corresponding.yang file.
