ExtremeWireless AP3917i/e

Mounting the AP using the KT-147407-01 bracket to a flat surface

The KT-147407-01 bracket can be attached to a flat surface and a pole with 1-axis of tilt. The bracket has three parts:

Flat part with two holes on the metal surface (used to attached the AP to a flat surface)
1-axis tilt bracket
Boxed pole bracket part with step edges (used to attach the AP to a pole when 1-axis tilt is not required)

Attaching the AP to a flat surface using the flat part of the bracket and 1-axis tilt bracket

Use four M6 screws to attach the flat part of the KT-147407-01 bracket. This is the bracket that has two holes on the surface of the metal portion.
Use the tilt bracket as a template and mark the location of the two mounting screws.
Use two screws to attach the tilt bracket to the mounting surface.
Use four M6 screws to attach the wall mounted part to the AP bracket. The AP bracket must be inside the wall mounted tilt bracket.
Adjust and tilt the AP to the desired angle. Tighten the four M6 screws to a torque of 45 in-lbs.

Mounting the AP using the KT-147407-01 bracket to a pole

The AP can be mounted to a pole using the KT-147407-01 by either using the 1-axis tilt or by using just the pole bracket part of the KT-147407-01 bracket.

If 1-axis tilt is not required, attach the pole part of the KT-147407-01 bracket to the AP using four M6 screws in the semi-circular slots.
If 1-axis tilt is required, use four M6 screws, split washers, and hex nuts to attach the pole bracket to the 1-axis tilt bracket.
Before attaching the pole bracket to the tilt bracket, ensure that you follow the steps mentioned in Attaching the AP to a flat surface using the flat part of the bracket and 1-axis tilt bracket to attach the other parts of the KT-147407-01 bracket.
Insert cable clamps that are ½" wide stainless steel through the long slots on the side of the pole bracket.
Locate the AP and bracket on the pole, insert the ends of the cable clamps, and tighten them to a torque of 11 in-lbs.