The Pole Mounting Bracket (WS-MBO-POLE01) is sold as a
separate accessory (part number 30520).
Determine the diameter of the pole.
Pole Diameter
Cable Clamp Size
<= 1" (25.4mm)
Use small cable clamp
5" - 7" (178mm)
Use large cable clamp
Other
Provide your own stainless steel cable clamp. The band
must be ½" (12.7mm) wide
Attach the cable clamp to the pole bracket. Open
the cable clamp by turning a flat bladed screwdriver counterclockwise. Then
insert the non-clamp end into the pole bracket through the holes.
Note
It is easier to install both clamps before attaching
to the pole or AP.
Attach the AP to the “Pole Mount” bracket using
four M4 screws. Tighten the four screws to a torque of 13.0-13.5 in-lbs.
Put the metal band around the pole and insert it into the clamp. Turn the clamp
screw clockwise, tightening the band around the pole.
Remove the black gland cap and the gasket under
it. Then separate the gasket from its plastic cage.
Attach the gland parts to the LAN cables and
insert the LAN cables into the mating connectors in the AP.
