Installing the Cable Gland Adapter Assembly

Install the cable gland adapter assembly onto LAN 1 or LAN 2 as follows:

  1. Insert the RJ45 cable onto the sealing nut (shown below).
    Click to expand in new window
  2. Slide the claw and seal onto the RJ45 cable (shown below).
    Click to expand in new window
  3. Plug the RJ45 cable into the port (shown below).
    Click to expand in new window
    Caution

    Caution

    Do not run the network cable through the cable conduit connector used for connecting the power cables. You must connect the network cable and power cables through separate connectors.
  4. Slide the seal and claw into the main body (shown below).
    Click to expand in new window
  5. Secure the seal nut onto the main body (shown below).
    Click to expand in new window
  6. Tighten the assembly by hand. Tighten the cap to 5 inch-pounds (shown below).
    Click to expand in new window
    Note

    Note

    There should still be some visible threads after you torque in the cap.
9035166-02