ExtremeGuest Server Settings

To configure the ExtremeGuest server, take the following steps:

1. Go to Configure > ExtremeGuest and select Add.
2. Configure the following parameters:

   IP Address

   IP address of the ExtremeGuest server.

   Name

   Name of the ExtremeGuest server.

   FQDN

   Fully-qualified domain name of the ExtremeGuest server.

   Authentication Timeout Duration (Seconds)

   Determines a timeout value, in seconds, for the RADIUS server connection.

   Authentication Retry Count

   Determines the number of times ExtremeCloud IQ Controller will attempt to authenticate an end user.

   Authorization Client UDP Port

   User Datagram Protocol (UDP) port number used for client authentication. UDP needs only one port for full-duplex, bidirectional traffic.

   Accounting Client UDP Port

   UDP port number used for client accounting. User Datagram Protocol (UDP) needs only one port for fullduplex, bidirectional traffic.

   Shared Secret

   The password that is used to validate the connection between ExtremeCloud IQ Controller and the ExtremeGuest server.

   • Mask—Determines if the Shared Secret or password value is displayed on the user interface. Enable Mask to display dots in place of the Shared Secret or password value. To display the password characters, clear the Mask check box.

   ExtremeGuest User Name

   User ID that ExtremeCloud IQ Controller Callback Manager uses to access the ExtremeGuest server.

   ExtremeGuest Password

   The password that ExtremeCloud IQ Controller Callback Manager uses to access the ExtremeGuest server. The minimum password length is 6 characters.

   • Mask—Determines if the Shared Secret or password value is displayed on the user interface. Enable Mask to display dots in place of the Shared Secret or password value. To display the password characters, clear the Mask check box.