What's New in this Document

The following table describes information added to this guide for the Extreme Fabric Automation 2.3.0 software release.

Table 1. Summary of changes

Feature	Description	Link
Admin status	The efa inventory device interface set-admin-state command now supports comma-separated lists of IP addresses and a Fabric name.	Change the Admin Status of an Interface
Port speed	The efa inventory device interface set-speed command now supports comma-separated lists of IP addresses and a Fabric name.	Configure Physical Port Speed
Maximum transmission units	The following commands now support comma-separated lists of IP addresses and a Fabric name: efa inventory device interface set-mtu efa inventory device system set-mtu	Configure MTU at the Interface or System Level
Breakout ports	The following commands now support comma-separated lists of IP addresses and a Fabric name: efa inventory device interface set-breakout efa inventory device system unset-breakout	Configure Breakout Ports
Config-replay using startup-config	Backup restore using startup-config is supported.	Configure Backup and Replay
Tenant Service Enhancements	Configure Reload delay/cluster-track on CEP ports The efa tenant vrf create and efa tenant vrf update commands are updated to support Static route and BFD enhancements. The efa tenant epg create and efa tenant epg update commands are updated to support exclusion of Vlan/BD as cluster members. Support for BGP peer and peer-group neighbors	Idempotent Operations CEP Cluster Tracking VRF Static Route Configuration VRF BFD on Static Route Exclusion of VLAN/BD from Cluster Instance VRF Maximum-Paths VRF Redistribute BGP as a Service
IP Multicast Fabric Provisioning	IP multicast fabric configuration on both 3 stage and 5 stage Clos fabric is supported.	IP Multicast Fabric Provisioning
Syslog notifications over RELP	New support for this release.	Notification Service
Backup and restore	Support for manual and scheduled backups, and for the purging of system and supportsave backups files.	EFA System Backup and Restoration
VRF resilient hashing	New support for this release.	VRF Resilient Hashing
In-flight transaction reconciliation	New support for this release.	Transaction Handling after Failover or Restart
Administered partial success	Tenant APIs configurations can proceed if at least one of the legs of the MCT is reachable and operational.	Administered Partial Success
Supportsave script enhancement	With this release, the supportsave script also captures the output of efa-show-running-config command.	Display EFA Running Configurations
Host name and IP address changes	New support for this release.	Change the Host Name or IP Address
Monitoring EFA Status	New support for this release.	Monitoring EFA Status

For more information on this release, refer to the Extreme Fabric Automation Release Notes.