For enhanced security, you can enable or disable a USB port on a switch. The USB port is enabled by default.
ExtremeSwitching X450-G2, X460-G2, , X590, X670-G2, X435, X440-G2, X465, X620, X690, X695, X870, 5320, 5420, 5520 series switches.
Stack support is not available. You need to enable this command individually on each node in a stack.
To enable the USB port, use the following command:
enable switch usb
To disable the USB port, use the following command:
disable switch usb
To show the status of the USB port, use the following command:
show switch usb