Enable Load Balancing

About this task

The NPB application supports GTP tunnel ID based load balancing.

Procedure

  1. Enter the interface port-channel configuration mode. 
    Device# configure terminal
Device#(config)# interface port-channel 1
Device(config-if-po-1)#
  2. Enable load balancing. 
    Device(config-if-po-1)# load-balance src-dst-ip-l4port
    Note

    Note

    For tunnel ID based load balancing, go to step 3.
  3. Enable tunnel ID based load balancing. 
    Device(config-if-po-1)# load-balance src-dst-ip-l4port-tid
9038134-00 Rev AA