Configure an Egress Policy

About this task

Follow this procedure to prepare packets for actions to be performed when leaving the 9920.

Procedure

Enter the Config mode.
```
device# configure terminal 
device(config)# 
```
Configure an ACL of type IPv4, IPv6, or MAC and any actions.
```
device(config)# ip access-list acl5-ipv4
device(config-ip-acl)# seq 15 permit ip any any count
```
The specified ACL and configured actions are bound to a listener policy.

Create the listener policy, including any action subcommands for the policy.

Note

A listener policy supports only one IPv4 ACL, IPv6 ACL, or MAC ACL.

device(config)# listener-policy lp-2 220
device(config-listener-policy)# match ip access-list acl5-ipv4
device(config-listener-policy)# strip vn-tag
device(config-listener-policy)# description “ABCD”

Configure an egress policy, and bind the listener policy, specifying any additional egress actions.

Note

An egress can be associated with only one listener policy.

device(config-egress)# egress e2
device(config-egress)# set listener-policy lp-2
device(config-egress)# description DirectTool
device(config-egress)# set encap encap-1 
device(config-egress)# precedence 1 interface ethernet 2/14

Configure the interface port and channel for egress traffic.
Note
In the following example, traffic is leaving on slot/port number 2/14.
```
interface ethernet 2/14
speed 100000
description To_Tool
no shutdown
```