show cfm

Use the show cfm command to display the Connectivity Fault Management (CFM) configuration.

device# show cfm 
Domain: md1 
Index: 1  
Level: 7  
  Maintenance association: ma5 
  MA Index: 5 
  CCM interval: 100 ms
  Bridge-Domain ID: 50 
  Priority: 7 
  MAID Format: Short 
  MEP   Direction  MAC              PORT       VLAN         INNER-VLAN   PORT-STATUS-TLV 
  ====  =========  =========        ====       ====         ===========  =============== 
  1     UP         609c.9f5f.700d   Eth 1/9    50           --           N      

Note

For the show cfm command to generate output, you must first enable CFM in protocol configuration mode.