Attaching a PW profile to a bridge domain

A pseudowire (PW) profile is applied by attaching it to a bridge domain.

1. From privileged EXEC mode, enter the global configuration mode.
   

   device# configure terminal

2. Enter bridge domain configuration mode.
   

   device(config)# bridge-domain 501

3. Configure a PW profile for the bridge domain.
   

   device(config-bridge-domain-501)# pw-profile pw_example

4. Return to privileged EXEC mode.
   

   device(config-bridge-domain-501)# end

5. Verify the configuration.
   

   device# show bridge-domain 501
   
   Bridge-domain 501
   -------------------------------
   Bridge-domain Type: MP , VC-ID: 501
   Number of configured end-points:  2 , Number of Active end-points: 2
   VE if-indx: 0, Local switching: TRUE, bpdu-drop-enable: TRUE
   PW-profile: pw_example, mac-limit: 0
   VLAN: 501, Tagged ports: 1(1 up), Un-tagged ports: 0 (0 up)
   Tagged Ports: eth1/6.501 
   Un-tagged Ports: 
   Total VPLS peers: 1 (1 Operational):
   
   VC id: 501, Peer address: 10.9.9.9, State: Operational, uptime: 4 sec           
         Load-balance: True , Cos Enabled: False, 
         Tunnel cnt: 4
         rsvp  p101(cos_enable:False cos_value:0) 
         rsvp  p102(cos_enable:False cos_value:0) 
         rsvp  p103(cos_enable:False cos_value:0) 
         rsvp  p104(cos_enable:False cos_value:0) 
         Assigned LSPs count:4 Assigned LSPs:p101 p102 p103 p104 
         Local VC lbl: 989041, Remote VC lbl: 983040, 
         Local VC MTU: 1500, Remote VC MTU: 1500, 
         Local VC-Type: 5, Remote VC-Type: 5 

Example

The following example shows how to attach a PW profile named pw_example to bridge domain 501.

device# configure terminal
device(config)# bridge-domain 501
device(config-bridge-domain-501)# pw-profile pw_example