Separately Ordered Components

The following accessories are available for the ExtremeWireless Access Point AP3965. For ordering information, contact Extreme Networks.

• Antennas. Refer to External Antennas and the ExtremeWireless External Antenna Site Preparation and Installation Guide for more information about these antennas. This document is available at: https://extremenetworks.com/downloads .
• Injector. The following 802.3at PoE injectors are recommended for use with the AP3965:
  • PD-9001GO-ENT (outdoor 802.3at PoE single port midspan)
  • PD-9501GO-ENT (single port 802.3at plus outdoor midspan)
  

  Note

  When the AP3965 is powered by the Power Injector, the DATA port of the injector should be connected to a non PoE switch or, if the switch is PoE capable, PoE must be DISABLED on the DATA port.
• Terminator cap. This part is listed as an optional accessory for the AP3965e. If you are not attaching eight antenna feeds to the AP3965e, you must use a terminator cap on the antenna connector(s) not being used.
  • WS-CAB-NTERM — Terminator, Standard Polarity, Type-N Plug, 50 OHM, 1W
• Cables to connect the lightning protectors on the enclosure to the antennas. All cables listed below have Standard Polarity Type-N jack and plug connectors:
  • WS-CAB-L200C20N—20 foot LMR200 cable
  • WS-CAB-L400C06N—6 foot LMR400 cable
  • WS-CAB-L400C20N—20 foot LMR400 cable
  • WS-CAB-L400C50N—50 foot LMR400 cable
  • WS-CAB-L400C75N—75 foot LMR400 cable
  • WS-CAB-L600C25N—25 foot LMR600 cable
  • WS-CAB-L600C50N—50 foot LMR600 cable
• Bracket (30514) WS-MBO-ART01 — Outdoor articulating mounting bracket for AP3965.