How to attach the AP3965 to a pole using an
articulating mount (WS-MBO-ART01).
About this task
To attach the AP3965 and
articulating mount to a pole:
Articulating Mount (WS-MBO-ART01) for AP3965
Procedure
Attach the small bracket on the WS-MBO-ART01 to
the pole bracket with four M4 screws, verifying that the AP orientation will be
upright before you tighten the brackets screws. Torque the screws to 12
in-lbs.
Insert two cable/pipe clamps into the pole bracket. Attach the clamps to the
pole where desired. Torque the clamp screws to 12 in-lbs.
Attach the AP to the large bracket with four M4
screws. Torque the screws to 12.0 in-lbs.
If the AP needs to be tilted up or down, remove
the screw (see red arrows in previous figure) and tilt the
AP to the desired angle. Re-insert the screw into the center hole in the black
part of WS-MBO-ART01. Torque the screw and nut to 12 in-lbs.
If the AP needs to be turned sideways, remove the
screw (see red arrows in previous figure) and tilt the
AP to the desired angle. Re-insert the screw into the center hole in the black
part of WS-MBO-ART01. Torque the screw and nut to 12 in-lbs.
Remove the black gland cap and the gasket under it. Then separate the gasket
from its plastic cage.
Attach the gland parts to the LAN cables and
insert the LAN cables into the mating connectors in the AP. For more
information, see Attaching Antennas.
Hand tighten the gland nuts and then tighten the nuts to a torque of 10
in-lbs.
