Installing the Cable Gland Adapter Assembly

About this task

Install the cable gland adapter assembly onto LAN 1 or LAN 2 as follows:

Insert the RJ45 cable onto the sealing nut (shown below).
Slide the claw and seal onto the RJ45 cable (shown below).
Plug the RJ45 cable into the port (shown below).

Caution
Do not run the network cable through the cable conduit connector used for connecting the power cables. You must connect the network cable and power cables through separate connectors.
Slide the seal and claw into the main body (shown below).
Secure the seal nut onto the main body (shown below).
Tighten the assembly by hand. Tighten the cap to 10 inch-pounds (shown below).