Unpacking the AP3965

About this task

Unpack the AP3965 as follows:

Procedure

  1. Open the box and remove the packing material protecting the AP3965.
  2. Verify that the contents of the carton contains the items listed below.
    Table 1. Contents of the AP3965 Carton
    Quantity Item
    1 AP3965 Quick Reference
    1 AP3965i/e model that you ordered.
    Under the cardboard separation:
    1 H-shaped bracket that is used for mounting the AP.
    1 Metal bracket for attaching the AP to a pole, pipe, or mast.
    1 #10AWG ground wire with a ring terminal crimped on it (6 foot length)
    The following hardware is included:
    4 Additional Hex nuts for the concrete anchors.
    4 Concrete wall anchor assemblies that include the anchors, a flat washer, and a hex nut.
    4 Split Washers for the concrete anchors.
    4 Cable clamps, all are ½" wide. Two clamps accommodate a 2.5" maximum diameter pole and two clamps accommodate a 6”-7” diameter pole.
    8 Screw assemblies, size M4, that include the screws, flat washers, and split washers.
    1 Ground Screw assembly, size M4, that include the screw, star washer, and split washer.
    Optional: You may also need antennas, terminators, or cables. Refer to Separately Ordered Components for product numbers.
    Note

    Note

    Before mounting the AP3965, read the RF Safety Distance.
  3. Perform a visual inspection of the AP3965 for any signs of physical damage. Contact Extreme Networks if there are any signs of damage.