Install the Access Point Under-Seat
The AP5050U is used with the EIO-04 mounting kit for under-seat
installation.
The EIO-04 under-seat mounting kit can be installed on a:
- Slope
- Flat horizontal surface such
as stadium floor
- Flat vertical surface such as
stadium riser
Note
For stadium riser installations, note the following items:
- If the service
panel base extends above the stadium riser, seal or cover the
EIO-03-SP Service panel openings to prevent material from
entering.
- Leave
approximately 1-inch between the outdoor access point bottom and
the floor. The gap will ensure that water that on the exterior
surface drips away.
- When you mount the AP on a riser with
the metal "L" bracket only and not with a large metal sloping bracket, it is
recommended that you add a 3mm-thick stainless steel washer between the “L” brackets
and the riser on all of the anchors. The washer provides proper drainage during
storms.
